Mimic Infotech Private Limited

E2B-M30LS15-M1-B1. Proximity sensor, LITE, inductive, nickel-brass, long body, M30, shielded, 15 mm, DC, 3-wire, PNP-NO, M12 plug-in

200 V Three-phase Input Power Supplies A solution to three-phase balance problems
3-phase power supply, 400 VAC, 480 W, 24 VDC, 20 A, DIN rail mounting

Banner Engineering AT-FM-10K Control Module, Two Hand, Solid State (NPN/PNP), Relay (Aux. NC), 200W, 60698

Tektronix is a well-known manufacturer of oscilloscopes and other test equipment. They produce both digital and analog oscilloscopes, although analog models have largely been phased out in favor of digital ones due to their greater versatility and ease of use.

An analog oscilloscope from Tektronix would typically feature:

 

1. Cathode Ray Tube (CRT): This is the traditional display for analog oscilloscopes, where waveforms are displayed as the electron beam moves across the screen.

2. Triggering System: This feature allows you to stabilize waveforms by ensuring the oscilloscope starts drawing the waveform at the same point each time.

3. Input Channels: Analog oscilloscopes often have one or more input channels (for example, a dual-channel oscilloscope would have two inputs) for measuring different signals.

4. Controls: Manual controls for time/div, volts/div, and other settings allow you to adjust the scope for different signals.

5. Real-time Signal Processing: Unlike digital oscilloscopes, analog oscilloscopes directly show the signal as it is without the need for digitization, which can offer more natural viewing for certain types of signals.